SCHEDIO

Cosmetic Milling

Particle size distribution, color enhancement and uniformity are critical for cosmetic powders and one of the most common techniques used to achieve it is micronization through jet milling.

your 360 images

Milling is one of the most common techniques to help break down large particles to finer ones, which is used for formulations of different cosmetic products.

The pin mill and hammer mill is a mechanical process used for gross milling of large particles greater than 1mm, crushing them into small powder form, usually below 100 microns.

Schedio offers a milling body predisposed for the installation of both pin and hammer mill within.

Pin mill

The equipment uses a rotor and stator with a special comminution geometry to allow the powder milling. The parts can easily be replaced with other disk geometries in order to set-up the best configuration depending on product characteristics.

Hammer mill

The powder enters the mill through a front opening, into the milling chamber. A rotor presses the powder against a sieve, which selects the particles according to its mesh dimension. The milling body is predisposed for the assembly of both hammer and pin mill.

Group 35
Group 34
Group 36

Technical info

U1
PIN & HAMMER MILL SPM / SMH 100 SPM / SMH 160 SPM / SMH 250
nominal productivity (Kg/h) 1 min - 50 max 3 min - 150 max 5 min - 300 max
img

Cosmetic Milling

Technical info

U1
PIN & HAMMER MILL SPM / SMH 100 SPM / SMH 160 SPM / SMH 250
nominal productivity (Kg/h) 1 min - 50 max 3 min - 150 max 5 min - 300 max

Why choose Schedio?

Direct line

Login for Customer Area

This content is reserved for Schedio SA customers only. For access, you must be a registered customer with us.